2S LiPo Battery 6200 mAh 50C 7.4 V Lipo Battery Hard Case Compatible with Axial 1/8 1/10 RC Aeroplane Helicopter RC Car Truck Boat (2 Packs)

Product Description
High-output 2S 6200mAh 50C LiPo pack built for serious RC action. Delivers stable 7.4V with true 50C discharge – enough punch for buggies, trucks, and boats. 10AWG soft silicone wires reduce resistance.Lightweight 304g design gives you longer run times without weighing down your vehicle.

Specification

• Chemistry: Lithium Polymer (LiPo)

• Configuration: 2S1P (2 cells in series, 1 parallel)

• Nominal Voltage: 7.4V

• Cell Voltage Range: 3.2V – 4.2V per cell

• Capacity: 6200mAh

• Recommended Charge Rate: 0.5C–1C (3.25A–6.2A)

• Max Continuous Discharge: 50C

• Balance Plug: JST-XH (2S)

• Discharge Plug: Deans T / XT60 / EC5 (optional)

• Wire: 10AWG ultra-flexible silicone, low resistance

• Dimensions (L×W×H): 139×47×25mm ±3mm (5.47×1.85×0.98 in)

• Weight: 304g ±2g (0.67 lb / 10.72 oz)

Packing Included

• 2 × 7.4V 6200mAh 50C LiPo battery packs Hard Case

Application

• 1/8 & 1/10 scale off‑road buggies and truggies

• Touring cars, drift cars, and high‑speed boats

• FPV racing drones and medium multirotors

• RC aircraft and EDF jets requiring 2S power

• Direct replacement for any 7.4V LiPo system with Deans T plug

Please Notice

• Always use a LiPo‑compatible charger in balance mode – never NiMH/NiCd settings.

• Charge at 0.5C–1C (3.25A–6.2A); do not exceed 1C unless you monitor temperature.

• Set ESC cutoff to 6.0V minimum (3.0V/cell) to prevent over‑discharge.

• Store at 3.8V–3.85V per cell when not used for over 3 days.

• Inspect for puffing or damage before each run – retire swollen packs immediately.

FAQ

Q1: Can I use this battery with an EC3 or XT60 connector?
Yes,use adapter, or replace the connector. Use a quality adapter to avoid voltage drop.

Q2: How long will it run on a full charge?
In a 1/10 buggy with a typical motor, expect 15–25 minutes of aggressive driving; lighter setups can exceed 30 minutes.

Q3: Can I charge both packs at the same time?
Only if your charger has dual outputs or you use a parallel board – set total current to 6.2A per pack and balance each properly.

Q4: The pack gets warm after use – is that normal?
Mild warmth (under 60°C) is normal. If hot or swollen, stop immediately and check your gearing and LVC setting.

Q5: How many cycles can I get?
With proper care (1C charging, storage voltage, no deep discharge), expect 150–200 cycles with >80% capacity retained.